gdmの設定

 1  # GDM Configuration Customization file.
 2  #
 3  # This file is the appropriate place for specifying your customizations to the
 4  # GDM configuration.   If you run gdmsetup, it will automatically edit this
 5  # file for you and will cause the daemon and any running GDM GUI programs to
 6  # automatically update with the new configuration.  Not all configuration
 7  # options are supported by gdmsetup, so to modify some values it may be
 8  # necessary to modify this file directly by hand.
 9  #
10  # Older versions of GDM used the "gdm.conf" file for configuration.  If your
11  # system has an old gdm.conf file on the system, it will be used instead of
12  # this file - so changes made to this file will not take effect.  Consider
13  # migrating your configuration to this file and removing the gdm.conf file.
14  #
15  # To hand-edit this file, simply add or modify the key=value combinationin
16  # the appropriate section in the template below.  Refer to the comments in the
17  # /usr/share/gdm/defaults.conf file for information about each option. Also
18  # refer to the reference documentation.
19  #
20  # If you hand edit a GDM configuration file, you should run the following
21  # command to get the GDM daemon to notice the change.  Any running GDM GUI
22  # programs will also be notified to update with the new configuration.
23  #
24  # gdmflexiserver --command="UPDATE_CONFIG <configuration key>"
25  #
26  # e.g, the "Enable" key in the "[debug]" section would be "debug/Enable".
27  #
28  # You can also run gdm-restart or gdm-safe-restart to cause GDM to restart and
29  # re-read the new configuration settings.  You can also restart GDM by sending
30  # a HUP or USR1 signal to the daemon.  HUP behaves like gdm-restart and causes
31  # any user session started by GDM to exit immediately while USR1 behaves like
32  # gdm-safe-restart and will wait until all users log out before restarting GDM.
33  #
34  # For full reference documentation see the gnome help browser under
35  # GNOME|System category.  You can also find the docs in HTML form on
36  # http://www.gnome.org/projects/gdm/
37  #
38  # NOTE: Lines that begin with "#" are considered comments.
39  #
40  # Have fun!
41
42  [daemon]
43  KillInitClients=true
44  StandardXServer=/usr/bin/Xvfb
45  VTAllocation=false
46
47  [security]
48  AllowRoot=true
49  AllowRemoteRoot=true
50
51  [xdmcp]
52  Enable=true
53
54  [gui]
55
56  [greeter]
57
58  [chooser]
59
60  [debug]
61
62  # Note that to disable servers defined in the defaults.conf file (such as
63  # 0=Standard, you must put a line in this file that says 0=inactive, as
64  # described in the Configuration section of the GDM documentation.
65  #
66  [servers]
67
68  # Also note, that if you redefine a [server-foo] section, then GDM will
69  # use the definition in this file, not the defaults.conf file.  It is
70  # currently not possible to disable a [server-foo] section defined
71  # in the defaults.conf file.
72  #
73  [server-Standard]
74  name=Standard server
75  command=/usr/bin/Xvfb